HP ILO 100A Configuration Instructions

Setting up a static ILO IP address from the BIOS Setup Utility


By default, LO100 has DHCP enabled and automatically negotiates an IP address. To disable DHCP and 
enable a static IP address:

  1. Press the F10 key during POST to enter the BIOS Setup Utility.
  2. Press the right arrow (→) key to navigate to the Advanced menu.
  3. Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
  4. To set your network BIOS settings, choose one of these options:
    • On ML110 G5 and ML150 G5 servers:
    • i. Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.Configuration 15
    • ii. On DHCP IP Source, select Disabled.
    • iii. Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and 
    • gateway address (press the Tab key to move between address fields).
    • On ML115 G5 servers:
    • i. Press the down arrow (↓) key to scroll to the BMC LAN Configuration menu. Press the Enter
    • key.
    • ii. Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.
    • iii. On DHCP IP Source, select Disabled.
    • iv. Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and 
    • gateway address (press the Tab key to move between address fields).

    • o On DL120 G5 servers:
    • i. Press the down arrow (↓) key to scroll to the LAN Settings menu. Press the Enter key.
    • ii. On IP Address Assignment, select Static.
    • iii. Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and 
    • gateway address (press the Tab key to move between address fields).

    • On DL160 G5, DL165 G5, DL180 G5, and DL185 G5 servers:
    • i. Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter key. 
    • ii. On DHCP IP Source, select Disabled.
    • iii. Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and 
    • gateway address (press the Tab or period (.) key to move between address fields).
    • On SL165z G6 servers:
    • i. Press the down arrow (↓) key to scroll to IPMI Configuration. Press the Enter key. 
    • ii. Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter key.
    • iii. Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.
    • iv. Select either of the following:
    • — To set BMC NIC to Disabled, press the Enter key.
    • — To save all changes and exit, press the F10 key.
5. Press the F10 key to save and exit.

For Further Information, please see the attached HP document on this page.

Ċ
Manabu Tokunaga,
Nov 21, 2011, 7:19 AM
Comments